The SeaSucker 4-Rod Holder with two 114 mm Vacuum Mounts This is SeaSucker’s all purpose boat rod holder; its purpose is both rod transportation and light trolling. Capable of...
This is SeaSucker’s flagship boat rod holder; its primary purpose is both trolling and rod transportation. This beast is capable of trolling your heaviest rods / reels; just mount it on a reasonably smooth and flat surface.
Attach the boat rod holder where you need it; then if you need to move it elsewhere it can be removed in seconds! All it needs is a reasonably smooth and flat surface to attach the three integrated SeaSucker 152 mm Vacuum Mounts. There is plenty of surface area compatible with our vacuum mounts in fibreglass and aluminium boats. A few pumps on the vacuum mount pump is all it takes to install this beast of a boat rod holder. Lift the vacuum cup tab and it pops off. To protect the vacuum mount when not in use press the included protective cover over the vacuum cup and you're done.
Three 152 mm Vacuum Mounts packing 270 kg of holding power are pre-nstalled on the 813 mm aluminium track using marine grade stainless steel hardware. Six white PVC rod holders slide onto a 813 mm anodized aluminium track. The rod holder's position on the track is fully adjustable; move them by squeezing the locking clamp on the side of the rod holder. Rod holder internal dimensions: 304 mm x 44 mm; they are pinned at the bottom for slotted rod butts.
Also refer to the SeaSucker Vacuum Mount User Guide for detailed vacuum mount specifications and instructions.
|Maximum Pull Rating (each):||90 kg|
|Load Carrying Capacity (each):||31.75 kg|
|Vacuum Mount Diameter:||152 mm|
|Vacuum Mount Height when mounted:||46 mm|
|Vacuum Mount Height at rest:||56 mm|
|Housing Top Diameter:||60 mm|
|Housing Height Only:||33 mm|
|Housing Top Slot Width:||7 mm|
|Housing Top Slot Length:||14 mm|
|Housing Centre Thread:|| ¼-20
|Rod Holder Internal Diameter:||44 mm|
|Rod Holder Internal Depth:||304 mm|
|Aluminium Track Length:||813 mm
Like our motto says NO DRILLS! NO SCREWS!! NO PROBLEMS!!!
A Florida-based designer, manufacturer, wholesaler and retaile...
Conner steals the show with showing how seasuckers work.
How to clean your SeaSucker vacuum cup.
http://www.seasucker.com SeaSuckers are powerful vacuum-cup mo...
The SeaSucker 4-Rod Holder with two 152 mm Vacuum Mounts This is SeaSucker’s all purpose boat rod holder; its purpose is both rod transportation and trolling. Capable of transporting...
The 114 mm Black Vacuum Mount with Low Profile (LP) Housing The Low Profile 114 mm Vacuum Mount by SeaSucker is 8 mm shorter than our standard 114 mm Vacuum Mount. It also has two stainless steel...