The SeaSucker Swing Arm Cup Holder is a single cup holder bolted to a powerful 114mm SeaSucker Vacuum Mount.
All it needs is a reasonably smooth and flat surface to attach the SeaSucker 114 mm Vacuum Mount. There is plenty of surface area compatible with our Vacuum Mounts in fibreglass and aluminium boats. A few pumps on the Vacuum Mount pump is all it takes to install this Cup Holder. Lift the Vacuum Cup tab and it pops off. To protect the Vacuum Mount when not in use press the included Protective Cover over the Vacuum Cup and you're done.
The cup holder has a slot in the side for mug handles and is gimbaled so that it swings freely and will adjust its angle with the boat's lean. Comes with a SeaSucker insulated stubbie holder! Please Note: Plastic Handle in photo not included.
Also refer to the SeaSucker Vacuum Mount User Guide for detailed vacuum mount specifications and instructions.
|Maximum Pull Rating:||45 kg|
|Load Carrying Capacity:||18.14 kg|
|Vacuum Mount Diameter:||114 mm|
|Vacuum Mount Height when mounted:||45 mm|
|Vacuum Mount Height at rest:||52 mm|
|Housing Top Diameter:||60 mm|
|Housing Height Only:||33 mm|
|Housing Top Slot Width:||7 mm|
|Housing Top Slot Length:||14 mm|
|Housing Centre Thread:|| ¼-20
Like our motto says NO DRILLS! NO SCREWS!! NO PROBLEMS!!!
The 114 mm Black Vacuum Mount with Low Profile (LP) Housing The Low Profile 114 mm Vacuum Mount by SeaSucker is 8 mm shorter than our standard 114 mm Vacuum Mount. It also has two stainless steel...
Lee's Tackle AO8715CR MKII 15ft Centre Rigger Bright Silver Poles with Black Spike Cast from marine grade anodized aluminium in Bright Silver the Lee's AO8715CR 15ft (4,572 mm)...