SeaSucker
iPad Galaxy White Tablet Mount
SeaSucker White iPad / Galaxy Mount The SeaSucker iPad / Galaxy Mount is designed to work with almost any tablet. There are no device specific brackets that must be replaced every...
Free Australia-Wide Shipping for orders over $200
The SeaSucker iPad / Galaxy Mount is designed to work with almost any tablet device. There are no device specific brackets that must be replaced every time you upgrade your tablet. It attaches to the back of your iPad, Galaxy or any other tablet device that has 114 mm of clear space behind the tablet.
The SeaSucker iPad / Galaxy Mount is powered by two 114 mm Vacuum Mounts; packing a total of 90 kg of pulling power. Here are just a few suggestions as to where you can mount your SeaSucker iPad / Galaxy Mount:
The SeaSucker iPad / Galaxy Mount has a maximum reach of 27 cm and has its own specialised housings with 1/4-20 inserts on the top and the side. This enables the Vacuum Mounts to be mounted at 90 degrees to the flex-arm allowing you to optimise your set up. When finished the SeaSucker iPad / Galaxy Mount packs away into its compact zippered travel case.
Please Note: This product may not work on the iPad Series 1 or the iPad Pro 4. This is due to the iPad logo not being a perfect seal. If you have this tablet you may have to apply a sticker over the logo or consider purchasing a LifeProof Case, this is available through the LifeProof Case store in Sydney Australia
Like our motto says NO DRILLS! NO SCREWS!! NO PROBLEMS!!!
Also refer to the SeaSucker Vacuum Mount User Guide for detailed vacuum mount specifications and instructions.
Maximum Pull Rating (each): | 45 kg |
Load Carrying Capacity (each): | 18.14 kg |
Vacuum Mount Diameter: | 114 mm |
Vacuum Mount Height when mounted: | 45 mm |
Vacuum Mount Height at rest: | 52 mm |
Housing Top Diameter: | 60 mm |
Housing Height Only: | 33 mm |
Housing Top Slot Width: | 7 mm |
Housing Top Slot Length: | 14 mm |
Housing Centre Thread: | ¼-20 |