The SeaSucker 4-Rod Holder with two 114 mm Vacuum Mounts This is SeaSucker’s all purpose boat rod holder; its purpose is both rod transportation and light trolling. Capable of...
This is SeaSucker’s purpose built boat rod holder; its primary purpose is rod storage along your gunwales. Whilst all other SeaSucker boat rod holders store rods vertically this boat rod holder can store your rods and reels horizontally. Capable of transporting up to six light to medium rods / reels with ease; just mount it on a reasonably smooth and flat surface.
There is plenty of surface area compatible with our vacuum mounts in fibreglass and aluminium boats. A few pumps on the vacuum mount pump is all it takes to install this boat rod holder. Lift the vacuum cup tab and it pops off. To protect the vacuum mount when not in use press the included protective cover over the vacuum cup and you're done.
The number of rods and reels you can transport will depend on the rod and reel combination. The smaller the rod and reel combination the more outfits the SeaSucker Horizontal Rod Holder can carry. A rubber insert holds multiple rods criss-crossed between the units, secured with a solid Velcro-backed strap.
Each SeaSucker Horizontal Rod Holder is bolted to a 114 mm Vacuum Mount packing 45 kg of holding power. The two 114 mm Vacuum Mounts in this kit pack a combined 90 kg of holding power. It’s also great for transporting Gaff, Nets and Boat Hooks. The SeaSucker Horizontal Rod Holder is sold in pairs.
The SeaSucker Horizontal Rod Holder will not work overhead - check out our Overhead Rod Holders as an alternative.
Also refer to the SeaSucker Vacuum Mount User Guide for detailed vacuum mount specifications and instructions.
|Maximum Pull Rating:||45 kg|
|Load Carrying Capacity:||18.14 kg|
|Vacuum Mount Diameter:||114 mm|
|Vacuum Mount Height when mounted:||45 mm|
|Vacuum Mount Height at rest:||52 mm|
|Housing Top Diameter:||60 mm|
|Housing Height Only:||33 mm|
|Housing Top Slot Width:||7 mm|
|Housing Top Slot Length:||14 mm|
|Housing Centre Thread:|| ¼-20
|Rod Holder Internal Diameter:||44 mm|
|Rod Holder Internal Depth:||304 mm|
|Aluminium Track Length:||406 mm
Like our motto says NO DRILLS! NO SCREWS!! NO PROBLEMS!!!
A Florida-based designer, manufacturer, wholesaler and retaile...
Conner steals the show with showing how seasuckers work.
How to clean your SeaSucker vacuum cup.
The 114 mm Black Vacuum Mount with Low Profile (LP) Housing The Low Profile 114 mm Vacuum Mount by SeaSucker is 8 mm shorter than our standard 114 mm Vacuum Mount. It also has two stainless steel...